V2000-c Rfid Access Control User Manual [ Ultimate ]

This method creates a user that can gain access by either presenting a valid card OR entering a valid 6-digit PIN.

All administration tasks—including registering fobs, altering passcodes, and modifying relay timing—must occur while the device is in . Entering and Exiting Programming Mode

The controller indexes users by allocating specific memory slots. Recording user slot assignments in an offline spreadsheet is highly recommended for tracking physical cards. Adding User Access V2000-c Rfid Access Control User Manual

Press and hold down the # key (or the reset button located on the back PCB, depending on production batch). the device while continuing to hold the key. Release the key after hearing a series of short beeps.

If you need help configuring a specific feature of your V2000-C system, please tell me: What you prefer (PIN, Card, or Both)? This method creates a user that can gain

We hope this manual helps you get the most out of your V2000-c Access Control System. For more specific technical support or advanced integration, you may also refer to general access control software documentation or contact a professional security installer.

Incorrect PIN, unregistered card, or programming syntax error. Alarm Triggered Tamper sensor activated or door forced open. Common Troubleshooting Scenarios Recording user slot assignments in an offline spreadsheet

The V2000-c supports three operational modes. Switch using [Master Code] + # + 19 [Mode] # .

Proper wiring is critical to avoid damaging the unit or the connected electronic locks. Always disconnect the power supply before wiring. Terminal Configurations : Power Positive (+12V DC) BLACK : Power Negative (GND)

To configure the unit, you must enter programming mode: * → [Master Code] → # (The yellow LED will light up, indicating you are in programming mode) . 4.2 Changing the Master Code Enter Programming Mode: * 123456 # Press 0 → [New 6-digit Master Code] → # Repeat [New 6-digit Master Code] → # Exit: * 4.3 Adding Users (Cards or PINs) Enter Programming Mode. Press 1 → [Read Cards] → # → * Add PIN Only: Enter Programming Mode. Press 1 → [Enter 4-6 digit PIN] → # → * 4.4 Deleting Users Delete a Card: Enter Programming Mode. Press 2 → [Read Card] → # → * Delete by PIN: Enter Programming Mode. Press 2 → [Enter PIN] → # → * 4.5 Setting Door Relay Time To adjust how long the door stays unlocked: Enter Programming Mode. Press 4 → [0-99 seconds] → # → * 5. Troubleshooting & Tips