Sanyo Mac 1200 Autoclave Manual Page

: Reaches up to 0.24 MPa (approx. 35 psi) to guarantee optimal steam penetration.

: Close the door and hand-tighten the wheel until snug. Do not over-tighten , as this can damage the rubber gasket.

Blocked exhaust valve, overloaded chamber, or faulty thermistor. sanyo mac 1200 autoclave manual

. Ensure it is clean and fully intact; even minor debris can cause steam leaks. Water Management

Improper loading and cycling are the leading causes of sterilization failures and equipment damage. Following standard operating procedures (SOPs) protects both your samples and the machine. 1. Preparation and Loading : Reaches up to 0

Carefully unlatch the handle, standing back as the lid opens to allow residual steam to escape safely away from your face and hands.

Whether you need specific schematic diagrams for Do not over-tighten , as this can damage the rubber gasket

: Set the desired temperature and timer (standard cycles often run for 45 minutes).

If you need a digital PDF copy of the original factory manual, utilize these resources:

An analog dial showing the internal pressure of the chamber. Always ensure this reads zero before attempting to open the lid. Status Indicator Lights:

105°C to 135°C for sterilization; 45°C to 60°C for incubation/warming. Maximum Pressure: Approximately 0.24 MPa (MegaPascals).