Often caused by a contaminated vacuum valve or O-ring. Weekly cleaning of the firing plate and head seal is recommended.
If the unit malfunctions, standard troubleshooting includes:
| Description | Part Number | |-------------|-------------| | Heating element (set of 2) | 063988 | | Thermocouple Type S | 063456 | | Door seal (silicone) | 068734 | | Vacuum pump (complete) | 059876 | | Mains filter | 074123 | | Main board (firmware 2.0) | 079951 | ivoclar programat p90 manual fixed
Muffle Type: High-quality heating coil with quartz glass protection. Programs: 99 programmable slots. Display: Digital LED.
: Use only a slightly moist cloth; never use solvents or compressed air, as this can distribute ceramic fiber dust. Often caused by a contaminated vacuum valve or O-ring
: Use the numeric keypad to enter program numbers (e.g., P01 to P08 for standard programs). is specifically designated for Dentin firings with vacuum. Key Parameters : Firing temperature. : Closing time (minutes) for the furnace head. : Holding time at the peak temperature. : Vacuum "on" and "off" settings.
is a stalwart, high-performance ceramic furnace designed for precise dental firing and glazing. While robust, ensuring it remains operational requires a clear understanding of its manual instructions, particularly when encountering errors. This article provides a comprehensive overview of the Programat P90 manual Programs: 99 programmable slots
: Indicates the battery in the control unit is low and needs replacement to save program data.
The is a legacy ceramic furnace released in 1987 , known for being the first Programat model with a membrane-sealed keypad. While a single "fixed" manual does not exist for this vintage device, the following resources and steps address common maintenance and technical issues. Common Error Codes & Troubleshooting
Routine maintenance is the most effective way to prevent unexpected faults. The manual recommends the following schedule for expendable parts and checks:
Remove the rear protective casing of the furnace head to expose the terminal leads for the heating element. Fix: Set a digital multimeter to Ohms ( Ωcap omega