Gordak 952 User Manual Updated Jun 2026
This updated section addresses specific community-reported issues with fixes.
Plug the soldering iron and hot air gun into the corresponding ports. Power On: Plug the station into an ESD-compliant outlet. 4. Operating Procedures: Updated Techniques 4.1. Using the Hot Air Gun Turn on the main power switch.
October 2023 Version: 3.1 (Updated Firmware & Safety Standards) gordak 952 user manual updated
Wait for the indicator LED to transition from a solid light to a rhythmic blink, signifying that the tip has stabilized at the target temperature.
The updated manual often includes a new section on error codes, thanks to the fault self-diagnosis features in newer models. Here are some common problems and their likely causes: October 2023 Version: 3
: Critical Step. When you turn off the hot air switch, the pump will continue to run until the handle temperature drops below 100°C. Do not unplug the station until the air stops blowing, as this prevents damage to the heating element. 3. Soldering Iron Use Compatibility : The iron uses standard 900M series tips .
| Problem | Possible Cause | Solution (From Updated Manual) | | :--- | :--- | :--- | | | Heater element aging or low voltage. | Test using a multimeter; replace the heating coil if resistance is out of spec (approx. 40-60 Ohms). | | Soldering iron "heats" but won't melt solder | Broken sensor wire or bad tip connection. | Check continuity of the sensor inside the handle. Ensure the retaining nut is tight. | | Digital display shows "S-E" or "H-E" | Sensor open circuit (Heater Error). | Replace the heating element or the thermocouple sensor in the handle. | | Temperature fluctuates wildly | Loose connection in the Triac circuit. | Inspect solder joints on the main PCB; reflow if necessary. | | Fan does not stop after shutdown | Triac shorted. | The auto-cooling relies on the triac switching off. Requires component replacement on PCB. | Check the heating element connection
Always solder in a well-ventilated area or use a dedicated fume extractor to avoid inhaling toxic flux vapors. Technical Specifications Specification Input Voltage 220V AC (or 110V AC depending on regional model) Power Consumption 270W (Hot Air Pump) / 60W (Soldering Iron) Air Pump Type Diaphragm Pump Airflow Capacity 0.3 to 24 L/min (Adjustable) Hot Air Temperature 150°C – 500°C Soldering Iron Temperature 200°C – 480°C Control Panel Diagram and Features The front panel is split into two distinct operating zones: 1. Hot Air Rework Section
Flip the master hot air switch on. The pump will initiate, and the air stream will begin heating.
Check the heating element connection; the element may need replacement.