Csi Bridge User Manual Guide

Before shaping the bridge, you must define what it is made of: Go to the tab.

Combines modeling, analysis, and design in a single user interface.

Bridges require unique moving load analysis, which CSiBridge simplifies via lanes and vehicle classes. Defining Lanes Go to the tab. Click Lanes > Add New Lane . csi bridge user manual

Specialized modules for reinforced and prestressed concrete bridges.

This guide acts as an overview of the CSiBridge user manual, helping professionals navigate the software's powerful capabilities. 1. Introduction to CSiBridge Before shaping the bridge, you must define what

[Layout Line] ──> [Define Lanes] ──> [Select Vehicles] ──> [Run Moving Load Case]

Reference your Layout Line and input the and total Lane Width . Defining Lanes Go to the tab

| Task | Manual Section | |------|----------------| | Define a curved bridge | Chapter: Bridge Geometry > Horizontal Alignment | | Apply temperature loads | Chapter: Loads > Temperature Gradient | | Run moving load analysis | Chapter: Analysis > Moving Loads | | Check prestressing losses | Chapter: Design > Prestress Losses |

Layout lines define the horizontal and vertical alignment of the bridge. Click .