Service Tool V3600 New! | Canon Printer

The printer is not in Service Mode. Turn the machine off and re-execute the button-pressing sequence carefully. Important Safety Warning

The software cannot detect any printer attached to the machine.

A small dialog box saying "A function was finished" or "Operation Completed" should appear.

When you print or clean the printheads, excess ink goes into internal absorbent pads. The printer counts these cycles using a digital counter. Once the counter reaches its limit, the printer locks itself to prevent ink leakage. Software V3600 unlocks the system by resetting that counter back to zero percent. Supported Canon Printer Models Canon Printer Service Tool V3600

Release both buttons. The power light should stay solid green once it enters Service Mode. : Open Service Tool V3600.exe on your Windows PC. Under the Main tab, find the Ink Absorber Counter section. Set the Counter Value to 0 and click Set . Confirm and Restart :

Using the Service Tool V3600 carries several risks that users should be aware of:

Turn off the printer but leave the power cable plugged in. The printer is not in Service Mode

Note: Later models may require higher versions (V4720, V4905, etc.). How to Use Canon Service Tool V3600

Release the button. The printer's LED light will flash and then stay steady green. This means it is in Service Mode. 3. Reset the Printer Run the Service Tool V3600.exe as Administrator. In the tool, look for the "Clear Ink Counter" section. Click "Main" and then click "Platen" . The tool should say "A function was finished." Click "EEPROM" to verify the counters are at 0.

I can give you the exact steps or tool version required for your machine. Share public link A small dialog box saying "A function was

Changes or fixes the regional firmware settings of the printer. The Core Problem: Understanding Error Code 5B00

Releasing the Reset button while continuing to hold Power, then pressing Reset five times (or twice, depending on the model).